Show Me Tell Me Questions

About the questions

You’ll be asked 2 vehicle safety questions during your car driving test.

The examiner will ask you one:

You’ll get one driving fault (sometimes called a ‘minor’) if you get one or both questions wrong.

You’ll fail your driving test if your driving is dangerous or potentially dangerous while you answer the ‘show me’ question.

‘Tell me’ questions

1. Tell me how you’d check that the brakes are working before starting a journey.

Brakes should not feel spongy or slack. Brakes should be tested as you set off. Vehicle should not pull to one side.

2. Tell me where you’d find the information for the recommended tyre pressures for this car and how tyre pressures should be checked.

Manufacturer’s guide, use a reliable pressure gauge, check and adjust pressures when tyres are cold, don’t forget spare tyre, remember to refit valve caps.

3. Tell me how you make sure your head restraint is correctly adjusted so it provides the best protection in the event of a crash.

The head restraint should be adjusted so the rigid part of the head restraint is at least as high as the eye or top of the ears, and as close to the back of the head as is comfortable. Note: Some restraints might not be adjustable.

4. Tell me how you’d check the tyres to ensure that they have sufficient tread depth and that their general condition is safe to use on the road.

No cuts and bulges, 1.6mm of tread depth across the central three-quarters of the breadth of the tyre, and around the entire outer circumference of the tyre.

5. Tell me how you’d check that the headlights and tail lights are working. You don’t need to exit the vehicle.

Explain you’d operate the switch (turn on ignition if necessary), then walk round vehicle (as this is a ‘tell me’ question, you don’t need to physically check the lights).

6. Tell me how you’d know if there was a problem with your anti-lock braking system.

Warning light should illuminate if there is a fault with the anti-lock braking system. Usually an amber ABS light.

7. Tell me how you’d check the direction indicators are working. You don’t need to exit the vehicle.

Explain you’d operate the switch (turn on ignition if necessary), and then walk round vehicle (as this is a ‘tell me’ question, you don’t need to physically check the lights).

8. Tell me how you’d check the brake lights are working on this car.

Explain you’d operate the brake pedal, make use of reflections in windows or doors, or ask someone to help.

9. Tell me how you’d check the power-assisted steering is working before starting a journey.

If the steering becomes heavy, the system may not be working properly. Before starting a journey, 2 simple checks can be made.

Gentle pressure on the steering wheel, maintained while the engine is started, should result in a slight but noticeable movement as the system begins to operate. Alternatively turning the steering wheel just after moving off will give an immediate indication that the power assistance is functioning.

10. Tell me how you’d switch on the rear fog light(s) and explain when you’d use it/them. You don’t need to exit the vehicle.

Operate switch (turn on dipped headlights and ignition if necessary). Check warning light is on. Explain use, which is visibility is less than 100 meters.

11. Tell me how you switch your headlight from dipped to main beam and explain how you’d know the main beam is on.

Operate switch (with ignition or engine on if necessary), check for the blue main beam warning light.

12. Open the bonnet and tell me how you’d check that the engine has sufficient oil.

Identify dipstick/oil level indicator, explain that you will remove the dipstick, wipe it clean with a rag or tissue. Once clean, the dipstick will be dipped in and when taken out, check the oil level against the minimum and maximum markers.

13. Open the bonnet and tell me how you’d check that the engine has sufficient engine coolant.

Identify the engine coolant reservoir and how to check whether the level of the coolant is inbetween the Maximum and Minimum level.

14. Open the bonnet and tell me how you’d check that the vehicle has sufficient hydraulic brake fluid.

Identify the hydraulic brake fluid reservoir and how to check whether the level of the fluid is inbetween the Maximum and Minimum level.

15. Open the bonnet and tell me how you’d check that the vehicle has sufficient screenwash.

Identify the screenwash fluid reservoir and how to check whether the level of the fluid is inbetween the Maximum and Minimum level.

You need to open the bonnet and tell the examiner how you’d do the check if you’re asked question 12, 13, 14 and 15.


‘Show me’ questions

Gloucester driving lessons. Automatic driving lessons. Driving test. driving test,driving instructors near me. driver education gloucester

Show Me Questions 

A demonstration of the show me questions the examiner will ask whilst you are driving 

Under the Bonnet

Demonstration of under the bonnet showing you to tell me questions